Loading ...
Loading ...
Loading ...
6
WF6
WF9 WF18
35.375”
35.375”
35.250”
23.500”
35.250”
TILES
MORTAR
BACKBOARD
TILES
MORTAR
BACKBOARD
TILES
MORTAR
BACKBOARD
CAUTION
1/4” THICK
35.375”
WIDE
36.250”
TALL
ROUNDED EDGES
ALL SIDES
CUSTOM SURFACE PANEL: Panels can also be made using materials such as mirror, glass, slate, marble or ceramic tile
for display in your waterfall. If tiling, use waterproof cement board as a backer, available at any building centre. Cut the
cement board to the size of your existing stainless steel panel. Ensure that the tiles can be used in a wet environment.
Porcelain tiles are recommended. Tile the surface, using thinset mortar, as you would a ceramic tile floor or bathroom wall. It
is not necessary to leave a gap or grout line in your tile. Ensure that the bottom edge of the tiles are flush with the bottom
edge of the cement board. You can choose any colour or pattern that you like, to match the room or surroundings. The water
will flow over the tiles, just as it does on the stainless steel panel, but be sure to keep the edges of the tiles fairly flush to each
other to prevent the water from splashing off. The stainless panel must be removed before installing any decorative panel.
Do not use glue to attach the tiles to the back panel, as some types of glue or epoxy will leach out into the water, causing the
filter and manifold to plug.
SEE-THRU WATERFALL (WF9ST)
The waterfall is not supplied with glass. This needs to be purchased separately by the customer. The size is as shown.
Before installing, clean the entire glass surface and stainless diffuser edge with the supplied TSP. Do not use glass
cleaner such as Windex on the side that has the water running on it. This will cause the water to break into streams
rather than running down the surface as a sheet.
During unpacking and assembly it is recommended that you wear work gloves and safety glasses for your protection.
Although we make every effort to make the assembly process as problem free and safe as possible, it is characteristic
of fabricated steel parts that the edges and corners may be sharp and can cause cuts if handled incorrectly.
Loading ...
Loading ...
Loading ...