Loading ...
Loading ...
Loading ...
LUBRiCATiON
The following parts should be oiled occasionally
with SAE No. 20 or No. 30 engine oil.
1. Tilt screw threads and pivot nut. (First Clean with
Craftsman Gum & Pitch Remover.)
2. Elevation screw threads and pivot nut. (First
Clean with Craftsman Gum & Pitch Remover.)
3. Cradle bearing points.
4. Bearing points in guard assembly, miter gauge
and rip fence.
LUBRtCATAON OF FLEXIBLE SHAFT
Flexible shafts do require periodic lubrication
because the core acts as a screw conveyor which
will pump the lubrication to one end of the shaft over
an extended period of operation. The frequency of
lubrication depends on how the saw is used. When
the saw operates continuously for long periods of
time, a lubrication schedule should be developed.
The time period may be every 80 or 100 hours. An
indication that the shaft needs lubrication is when it
becomes noisy. Conversely, when the saw has
limited and infrequent use. the grease will
GUARD _
_t- BEARING POINTS
eventually age and harden so that it wilt not provide
an adequate oil film between the core and casing
liner and must be replaced.
LUBRICATION PROCEDURES
1. Remove the core from the casing, clean the core
by washing with kerosene or an approved
solvent.
.
3.
.
Dry, the core.
Inspect the core for worn or broken wires. If core
is damaged, it should be replaced.
"Butter" the entire length of the core with a good
grade of general purpose bearing grease with a
minimum operating temperature of -40°F and
reassemble in casing. DO NOT force the grease
into the casing with a grease gun. Too much
grease will affect shaft life because it makes the
core work harder.
® @
l/ I{/\1 \
BEARING POINTS
RECOMMENDED ACCESSORIES
ITEM CAT. NO.
Steel Stand ............................ 9-22214
Caster Sets ................. 9-22222 or 9-22221
Solid Table Extension ................. 9-29957
7 In. Molding Head Set .................. 9-3217
7 In. Molding Head Set .................. 9-3218
7 In. Molding Head ...................... 9-3214
Molding/Dado Insert for 7 in.
Dia. Molding or Dado Head .......... 9-22271
Work Light ............................. 9-2480
ITEM CAT. NO.
7 In. Dia. Adjustable Dado Head
9-3261 - 9-3262 - 9-3263
7 In, Dia. Dado Head .................... 9-3257
Sanding Wheel ....................... 9-22723
Miter-Gauge Stop Rods ............... 9-29924
Miter-Gauge Hold-Down Clamp ....... 9-29928
Taper Jig ............................... 9-3233
Universal Jig ........................... 9-3235
Powe Tool Know How Handbook
Sawdust Collection System ............ 9-24242 Table Saw ........................... 9-2918
10" Dia. Sawblades with 5/8" Bore . See Catalog Cast iron Extension, 12 x 27 inches .... 9-22261
Work Light ............................. 9-2481 Rip Fence Bar ........................ 9-29969
Table Extension Kit ................... 9-29968
Loading ...
Loading ...
Loading ...