Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR SAW
9 SAWBLADE
7' BLADE GUARD
8 TABLE,NSERT / /__
M,TEROAUGE 10EXACT-I-COT1 > ANT'Z'C@CK
LOCK HANDLE _ \ _.._._iit_.._ / _ v.w
y ATTACHING FACING
4" TILT LOCK HANDLE "_,._'_' L_
(UNDERNEATH TABLE) _
2 ELEVATION HANDWHEEL 3 TILT HANDWHEEL
\
] ON-OFF SWITCH
1 ON-OFF SWITCH
CAUTION: Before turning switch on, make sure the
blade guard is correctly installed and operating
properly,
The On-Off Switch has a locking feature. THIS
FEATURE IS INTENDED TO PREVENT
UNAUTHORIZED AND POSSIBLE HAZARDOUS
USE BY CHILDREN AND OTHERS,
A. TO turn saw ON..stand to either side of the
blade never in line with it ... insert finger
under switch lever and pull END of iever out,
Do not cycle the motor switch on and off
rapidly, as this may cause the sawblade to
loosen. In the event this should ever occur
allow the sawblade to come to a complete
stop and retighten the arbor nut normally, no_
excessively. Never leave the saw while the
power is "ON".
B, TO turn saw OFF . . . PUSH lever in, Never
leave the saw until the cutting tool has come
to a complete stop.
C. TO lock switch in OFF position.., hold switch
IN with one hand ... REMOVE key with other
hand.
WARNING: FOR YOUR OWN SAFETY,
LOWER BLADE OR OTHER CUTTING
TOOL BELOW TABLE SURFACE. (IF BLADE
IS TILTED, RETURN iT TO VERTICAL (90 ° )
POSITION). ALWAYS LOCK THE SWITCH
"OFF". WHEN SAW IS NOT IN USE . . .
REMOVE KEY AND KEEP IT IN A SAFE
PLACE . . . ALSO . . . IN THE EVENT OF A
POWER FAILURE (ALL OF YOUR LIGHTS
GO OUT) TURN SWITCH OFF... LOCK IT
AND REMOVE THE KEY. THIS WILL
PREVENT THE SAW FROM STARTING UP
AGAIN WHEN THE POWER COMES BACK
ON.
KEY
(YELLOW PLASTIC)
¥
kk
27
Loading ...
Loading ...
Loading ...