Loading ...
Loading ...
Loading ...
- 15 -
2. A licensed electrician should set the amperage of the unit according
to the connected dedicated breaker associated with the hardwired
connection or NEMA outlet. Using the table on the previous page,
determine the voltage and amperage of the installation. Then, set the
unit’s DIP switch following the diagram below that corresponds with the
dedicated breaker’s voltage and amperage.
3. Reattach the wiring access panel you set aside
previously. Position the wiring access panel on
the charging station and secure it with three
of the M4 screws you removed earlier. Next,
reattach the lower front cover. Insert the tabs
into the slots on the front of the charging
station and slide the cover up and in place.
Secure the lower front cover at the bottom of
the charging station with the last M4 screw.
4. Coil the output cable into the cable cradle
and insert the EV connector into the dock on
either side of the charging station.
5. Turn the power back on at the circuit breaker if your charging
station was hardwired (SEV1600HW). For models SEV1600P1450
and SEV1600P650, plug the unit into the corresponding live NEMA
outlet. If correctly installed, the Power LED will illuminate a steady
green.
Loading ...
Loading ...
Loading ...