Loading ...
Loading ...
Loading ...
L1
L2
PE
CP
LED
- 12 -
3. Insert the two-pin plug (orange and blue wires) into the connector
to the left of the right terminal block.
4. Feed the output cable up into the charging station and secure by
screwing the outer plastic nut to the threaded ring. The threaded
ring must be securely tightened.
MOUNTING THE CHARGING STATION TO THE WALL
1. Using a drill fitted with a 5.5 mm or 7/32 inch drill bit, drill two pilot
holes into the stud where indicated by the mounting template.
2. Drive the 5.5 mm x 50 mm lag screw without a rubber washer into
the top pilot hole, leaving the head of the screw 6-7 mm above the
wall surface.
2. Insert the wires into the appropriate connectors in the right terminal
block as illustrated in the wiring diagram below.
L1 - Red Wire
L2 - Black Wire
PE - Green and
Yellow Wire
CP - Blue Wire
LED - Orange Wire
Loading ...
Loading ...
Loading ...