Loading ...
Loading ...
Loading ...
NEMA 14-50
Model SEV1600P1450
NEMA 6-50
Model SEV1600P650
L1 L2 PE
- 11 -
ATTACHING THE CORD AND PLUG TO THE CHARGING
STATION (MODELS SEV1600P1450 AND SEV1600P650 ONLY)
1. Ensure that you have an existing NEMA outlet that matches the
model you are installing. Alternatively, a licensed electrician may
install a NEMA outlet that corresponds with the specifications of
your model. Model SEV1600P650 has a NEMA 6-50 plug and model
SEV1600P1450 has a NEMA 14-50 plug. In addition, Schumacher
Electric recommends that a licensed electrician confirms that any
new or existing outlet complies with all local electrical codes and has
a designated circuit breaker compatible with the specifications and
requirements of the EV wall charger. See the sections Final Steps
and Specifications for more information. for more information.
CONNECTING THE OUTPUT CABLE TO THE CHARGING
STATION
1. The output cable should have five wires visible at the end opposite
the EV connector. Insert the wires through the right-hand opening
on the bottom of the charging station.
2. Route the cord through the left-hand opening on the bottom of the
charging station.
3. Inside the wiring access panel, there are two terminal blocks.
Securely insert wires into the left-hand terminal block as indicated
by the wiring diagram below.
4. Feed the cord up into the charging station and secure by screwing
the outer plastic nut to the threaded ring. The threaded ring must be
securely tightened
L1 - Red Wire
L2 - Black Wire
PE - Green Wire
Loading ...
Loading ...
Loading ...