Loading ...
Loading ...
Loading ...
14 remote controller installation Kelvinator Gas Continuous Flow hot water system
Remote controller installation
1. Crimp the lugs provided to the remote controller wiring.
Minimum 18AWG wire (No polarity).・Maximum 100m long
2. If installing the MAIN remote controller, attach the
crimped fork lugs on the end of the wiring to the
terminals on the back of the controller.
15
wiring terminals
15
3. Install the wiring downward through the cable trench and
out the bottom of the connector base.
4. Fix the remote controller in position using the two screws
provided or alternatively use another xing solution
suitable for the material to be xed to.
15
fork lugs
25mm
remote control
wiring
84mm
45mm
caution
• TheMAINremotecontrollermustbeinstalledindoors
and in an area that does not have the potential to
become wet or damp as it is NOT water resistant.
In potentially wet areas the SHOWER and ENSUITE
controllers should be used however all controllers
must be positioned so that they will not come into
direct contact with water.
• DONOTpositiontheremotecontrolsinthevicinity
of chemicals.
• DONOTpositiontheremotecontrolsoveracooker,
grill or toaster.
• DONOTpositiontheremotecontrolswherematerials
may spill onto them.
• Pleasenoteifthecontrolsaretobettedtoametal
surface an insulation plate should be provided behind
the mounting position.
Loading ...
Loading ...
Loading ...