Loading ...
Loading ...
Loading ...
Fig. 6
Fix the foam element centrally in the appliance plinth
trim.
The foam element is used to separate the incoming and
outgoing air currents and permits sufficient ventilation.
Weight of the unit door
Note
u
Before assembling the unit door, make sure that the
permitted weight for the unit doors is not exceeded
u
Otherwise damage to the telescopic rails and malfunc-
tions arising from this cannot be ruled out.
Model
Maximum weight of
unit door
S/UIKo 22.05 lbs (10 kg)
Side fastening
q
Installation below hard worktops such as granite.
q
With the adjusting feet completely screwed out, the
appliance is lower than the counter top.
q
Requirement: Cabinet side panel for the screw connec-
tion.
Top fastening
q
When the adjusting feet are screwed out completely,
the appliance sits slightly tensioned below the worktop.
q
No granite top.
4.3.1 Assembling the appliance
Fig. 7
u
If the appliance plinth trim is already installed, remove it
from the front.
u
Remove the mains cable from the back of the
appliance. Also remove the cable holder, other-
wise there will be vibration noise!
u
Position the mains cable using
a piece of string so that the
appliance can easily be
connected to the electricity
supply after it has been built-in
Fig. 8
NOTICE
Risk of damage to delicate floors!
u
Place a strip of cardboard under the height-adjustable
feet, approx. 4 in.x24 in. ( 10 cm x 60 cm ), one at either
side. Cut the strips out of the packaging. If the recess
heights are smaller than ( 826 mm ) cut the strips out of
a firm but thin material.
u
After the appliance has been slid in, remove the strips.
Fig. 9
With a 23-5/8 '' (600 mm) wide recess: Do not use strips.
With a 24-1/32 '' (610 mm) wide recess: Place the strips
on the side.
- The appliance is to the right of the adjacent cabinet: Fit
the strip to the left.
- The appliance is to the left of the adjacent cabinet: Fit
the strip to the right.
u
Place the strip under the top edge and stick it to the
side panel. The strip must not be shortened.
Top fastening
Start-up
8 * Depending on model and options
Loading ...
Loading ...
Loading ...