Loading ...
Loading ...
Loading ...
u
Attach the unit door on the adjusting bolts
Fig. 23 (13)
and loosely screw locknuts
Fig. 23 (10)
onto the
adjusting bolts.
u
Close the door.
u
Check the gap between the door and the surrounding
unit doors
u
To laterally align the unit door Move the unit door in the
X direction.
u
To align the unit door in the Y direction (height) and in
lateral inclination: Adjust the adjusting bolts
Fig. 23 (13)
with a screwdriver.
w
The unit door is flush and in alignment with the
surrounding unit fronts
u
Tighten the locknuts
Fig. 23 (10)
.
Fig. 24
u
Screwing the unit door to the appliance door.
u
Drill pilot holes in the door of the unit (you could make a
preliminary hole with a bradawl)
u
Screw the appliance door to the unit door with screws
through the mounting brackets.
Fig. 25
u
Align the unit door in depth Z : loosen the upper and
lower screws on the door, then move the door.
u
Do not allow the knobs and
sealing lips to contact the door -
important for function
u
Set an air gap of 3/32 '' (2 mm)
between the unit door and the
body of the unit.
Fig. 26
u
Check the fit of the door and re-adjust, if necessary
u
Tighten all screws
u
Tighten the locknuts
Fig. 26 (10)
with a hex wrench 13,
while counter-holding the adjusting bolts
Fig. 26 (13)
with a screwdriver.
Fig. 27
u
Position the upper cover and snap it into place.
Check the following points to make sure the appliance is
installed correctly Otherwise, icing up, the formation of
condensate, and malfunctions can occur
w
The door must close properly
w
The unit door must not touch the body of the unit
4.4 Adjust the fit of the door seal
It may be necessary to adjust the appliance door
depending on the weight of the unit door.
After assembling the unit door, check that the door seal is
fully fit up against the appliance body.
Fig. 28
Start-up
12 * Depending on model and options
Loading ...
Loading ...
Loading ...