Loading ...
Loading ...
Loading ...
EN
98
FLASH PHOTOGRAPHY
▸ Switch on the flash unit
▸ Set the desired guide number control mode (e.g. TTL or GNC =
Guide Number Control) on the flash unit
▸ Switching the camera on
▸ Tap the shutter button before each flash exposure to activate
exposure metering
• The flash unit may not fire if this step is missed by pressing
the shutter button down completely and skipping these
settings.
▸ Set the desired exposure mode, shutter speed and/or aperture
setting
• It is imperative to take note of the shortest flash sync speed,
as it determines whether a "normal" flash or an HSS flash is
fired.
▸ Select Flash Settings in the main menu
▸ Select Flash Mode in the submenu
▸ Select a setting
• The currently active mode is displayed on screen.
Notes
• A flash unit that is not ready to flash may cause incorrect
exposures or error messages.
• Studio flash systems may have a very long flash firing duration. It
may therefore be advantageous to select a slower shutter speed
than 1⁄180s when using such a system. The same applies for
RF-controlled flash firing for so-called "off-camera" flashes, as
the transmission time may cause a delay.
• Serial exposures and automatic bracketing with flash are not
available. With the camera set to one of these modes, there will
be no flash display on screen even if the flash unit is attached
and the flash will not fire.
• The setting (long-term synchronization) is unavailable and
grayed out if a flash unit is attached that is not system
compatible.
• Depending on the setting selected in the Auto ISO Settings menu,
the camera may not support slower shutter speeds, because an
increase in ISO sensitivity takes priority.
• Use a tripod to prevent blurring at slow shutter speeds.
Alternatively, you can select a higher sensitivity.
Picture Mode
Loading ...
Loading ...
Loading ...