Loading ...
Loading ...
Loading ...
PLACEMENT OF THE MOUNTING PLATE
1
Installation Instructions
Find the studs, using on e of th e followin g
methods:
A. Stud finder – a magn etic device wh ich
locates n ails.
B. Use a h ammer to tap lightly across the
moun ting sur face to find a solid soun d.
This will indicate a stud location .
After locating th e stud(s), find th e center by
probin g the wall with a small nail to fin d the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be 16w( 40.6 cm) or 24w( 61 cm) from this mark.
Draw a line down the cen ter of the studs.
TH E MICRO WAVE MUST BE CONNECTED TO
AT LEAST O NE WALL STUD.
1
Fold back all 4 carton flaps fully against carton
sides. Th en carefully roll the oven and carton over
onto the top side. The oven should be restin g in
the Styrofoam.
REMOVING THE M ICROWAVE
OVEN FROM THE CARTON/
REMOVING THE M OUNTING
PLATE
FINDING THE WALL STUDS
B
.
A
.
2
Wall
Studs
Center
3
Carton
Pull the carton up and off th e oven.
2
Styrofoam
3
1
Screws
Screws
Mounting Plate
5
4
Cut the middle of the outer protective plastic bag to
r
emove
the
oun ting late
m
p
Remove the installation instructions,use and care,
exhaust adapter, turntable ring, shelf, filters, glass
Do not remove
the Styrofoam protecting the front of the oven.
Remove the screws from each end of the mounting
plate. This plate will be used as the rear wall template
ba
g.
and for mounting. Reinstall the screws into the holes
where they were removed.
tray and the small hardware
please note: Do Not Remove plastic plug
EN-6
protective cover until just before hanging the unit.
Filters and Turntable
Ring below glass tray
Exhaust Adapter
Small Hardware Bag
Glass Tray
Keep the unit at least 8 inches away from the
counter top edge to prevent dropping because
of the heavy door.
Loading ...
Loading ...
Loading ...