Loading ...
Loading ...
Loading ...
pg-12
ERROR MESSAGES
1. Flow error
If you stop blowing or you do not breathe strongly enough, “Flow Error” will be displayed on the
LCD. Please wait and try again and the machine will return to the testing mode.
2. Sensor error
A. Check if the alcohol sensor is in the right place on the board.
B. If you still have the error message, replace the sensor.
3. The screen is blank after replacing the sensor.
A. The sensor is not connected correctly.
B. Check you have connected the white cable in the correct direction and it is clipped to the
connector.
TROUBLESHOOTING GUIDE
1. The machine is plugged in, but there is no power.
Make sure that the line attached to the power adapter is connected correctly to the power socket
on the bottom of the machine. Make sure the power point is turned on.
2. There is no audible alert or sound.
Call AlcoLimit Breathalysers during oce hours (9-5pm M-F) and they will guide you through a
quick sound test
3. You blow, but the machine does not respond.
Check if the display window shows an error eg: “Sensor error”. If so, refer to error messages above.
4. After testing, the machine does not go back to the waiting mode.
The machine displays the result %BAC for 10 seconds. In order to go back to the testing mode,
the alcohol blown into the machine must be eliminated completely.
The amount of alcohol increases the time required for this elimination to be competed,
but it normally does not exceed 4 minutes. If it takes more than four minutes, the sensor may be
malfunctioning. Replace the sensor and if the error continues contact AlcoLimit Breathalysers on
1300 667 661.
Please note that the software has an inbuilt function to prevent people using the device for ‘drinking
games’. If a level of 0.250%BAC or over is blown into the machine it will not allow any additional tests for
4 minutes.
FOR FURTHER ASSISTANCE PLEASE CALL 1300 667 661.
Version 1.0
RBT Wallmount
©
AlcoLimit
©
Loading ...
Loading ...
Loading ...