Loading ...
Loading ...
Loading ...
pg-10
1. Turn the power o. (Very Important!!)
2. Unlock the AlcoLimit RBT and open the unit
3. Locate the sensor module and remove the 4 screws as indicated above
4. Pull out the sensor board above in the direction of the arrow.
5. Unplug the connector (press the clip) and insert the new sensor board
6. Plug in connector (ensuring the correct orientation), push the sensor board
in its correct place and replace the 4 screws tightly.
7. Turn on the power and the AlcoLimit RBT will perform an accuracy check.
8. The replacement is complete.
If the front display remains blank (no power) the sensor is not connected
correctly. Disconnect and reconnect the white cable again, ensuring it is the
correct orientation
With each new sensor purchased or calibrated by AlcoLimit Breathalysers a
“Calibration Certicate” can be ordered for $22. If you require this for auditing
purposes please request at the time of purchase/calibration.
Be sure to le this in the correct place for record keeping purposes.
Version 1.0
RBT Wallmount
©
AlcoLimit
©
Loading ...
Loading ...
Loading ...