Loading ...
Loading ...
Loading ...
16
DOOR HANDLE INSTALLATION
CAUTION
Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.
NOTE
All set screws should be tightened so the screw is below the surface of the handle.
The handles should be drawn tight to freezer and refrigerator doors with no gaps.
Opening the opposite door while tightening the Allen screw makes installation easier.
The door handle may loosen over time or if it was installed improperly. If this hap-
pens, tighten the set screws on the handles.
Door Handle Mounting
Instructions
1. Remove handles from carton and
any other protective packaging.
2. Position refrigerator handle end
over upper and lower pre-installed
shoulder bolts (A) that are
fastened into door, ensuring the
holes for the set screws are facing
towards the opposite door.
3. While holding handle firmly
against door, fasten further
most upper and further most
lower Allen set screws (B) with
supplied Allen wrench.
4. Repeat steps 2 and 3 to install
opposite handle. Ensure the
holes for the set screws are
facing towards the first door.
5. Firmly tighten the inside Allen
set screws.
6. Position freezer handle end
over left and right pre-installed
handle shoulder bolts (A)
that are fastened to the door,
ensuring the holes for the set
screws are facing down.
7. While holding handle firmly
against door, loosely tighten far
right Allen set screw (B) with
supplied Allen wrench until
there is no gap between handle
and door.
8. Still holding the handle firmly
to the door, firmly tighten far
left Allen set screw (B) with
supplied Allen wrench.
9. Return to the far right Allen set
screw (B) and firmly tighten with
supplied Allen wrench.
10. Firmly tighten the inside Allen
set screws.
Mounting Refrigerator Handles
Mounting Freezer Handle
NOTE
When tightening the Allen set screws, it is
important that force be applied to the longer
arm of the Allen wrench supplied in the han-
dle packaging.
x2
x2
A
A
B
B
x2
x2
x2 x2
A A
A
A
B
B
B
B
Loading ...
Loading ...
Loading ...