Loading ...
Loading ...
Loading ...
rllr i7 t OTHER THnNGS TO KNOW
n,
continued from page 25
recharge). As you did in step c, use the SET/
CLEAR button [] to change the display from ON
to OFF, or from OFF to ON
e. Press RECHARGE DAY button [] to display a
flashing TUesday, WEdnesday, etc., each time
using the SET/CLEAR button [] to display either
ON or OFF as needed,
After recharge is either set or cancelled for
SAturday, press the PRESENT TIME AND DAY
button [] once again to return the present time
and day display_
2. SET THE FILL CYCLE MINUTES
a. Press and hold the RECHARGE TIME button []
until FILL shows in the display, then release
button []_ After a few seconds, the fill cycle
minutes (factory setting ..... 16) wilt flash,
b= Press the SET/CLEAR button [] to set the min-
utes of fill cycle needed, as shown in the regen-
eration table.,
NOTE: Press SET/CLEAR and quickly release to
move the display ahead 1 minute at a time. Or, hold
the SET/CLEAR button to move the display ahead
2 minutes each second. THE DISPLAY BEGINS
OVER AT 0 AFTER PASSING 59.
C. Press PRESENT TIME AND DAY button [] to
return the present time and day display°
NOTE: TO SET THE PRESENT TIME OF DAY,
AND DAY OF WEEK, SEE PAGE 17o
POUNDS OF SALT USED EACH REGENERATION
MINUTE-LENGTH
OF FILL CYCLE
POUNDS
SALT USED
10 2°9
12 3,,5
14 4.I
16 4.6
19 5,,5
25 7.,2
NOTE: You may get hard water between regenerations
ifyou set the timer for fewer fill minutes than the Regenera-
tion Table shows you to set.. A higher setting than need-
ed will waste salt,
27
Loading ...
Loading ...
Loading ...