Loading ...
Loading ...
Loading ...
Ii
SECTION 3
STEP BY STEP GUmDES TO RNSTALL
,i
ELECTRIC POWER OUTLET FOR YOUR
13.
The softener works on 24 vott, 60 Hz electric
power° The included transformer changes standard
120 volt AC house power to 24 voltso "Youmust plug the
A transformer into a t20 volt outlet only. Be sure the
outlet is always "live" so someone cannot turn it off by
mistake.
NOTE: The included transformer is made for inside
use onlyo Be sure the electrical outlet you plug the
transformer into is inside, to protect from weather
(see page 6).
FASTEN THE POWER CABLE AND PLUG
"_4,, IN THE TRANSFORMER
Looking at FIGo 16, fasten the 2 power cable lugs (1
under each screw) to the transformer as shown.
Tighten both screws. Then plug the transformer into
the electrical outlet.
When the transformer is plugged 14M ,,,-, ,--,--,t
Iin, 12:00 AM Sunday will begin _;, ,,.. '..-,_ I
flashing in the face plate display.
TURN ON THE GAS (OR ELECTRIC)
15. SUPPLY TO THE WATER HEATER AND
LIGHT THE PILOT.
1 6, CHECK LIST OF STEP BY STEP GUIDES
To be sure you have done all the steps to
install the softener, read the following list:
,i Is the house water flow going INTO the softener
valve INLET? Trace piping to be sure,. (steps 6
and 8)
,t Is the plumbing bypass valve (or 3 valves) set for
SERVICE? (step 11)
Is the valve drain hose connected the right way,
and without sharp bends or kinks that could stop
or reduce water flow? (step 9)
Is the softener power cable connected to the
transformer_..and isthe transformer plugged into
an inside, 120V-60Hz electrical outlet? (step 13
and 14)
_, Did you restart the water heater? (step 15)
CONNECTING TRANSFORMER
/
Screws
Power Cable (Hook either lead
under either transformer terminal,)
WATER
Transformer
AFTER CHECKING ALL OF THE ABOVE, GO TO SECTION 4, "SOFTENER START-UP" TO FILL THE
STORAGE TANK WITH SALT AND WATER, AND TO SET THE TIMER.
15
Loading ...
Loading ...
Loading ...