Loading ...
Loading ...
Loading ...
18
Inspect and properly tighten all parts of the exercise
bike regularly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, replace all the
batteries at the same time; most console problems are
the result of low batteries. To replace the batteries,
see assembly step 12 on page 9.
If the handgrip heart rate monitor does not function
properly, see step 5 on page 14.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed
switch, you must first
remove the Top Shield
(9). Using a flat screw-
driver, release the tabs
near the rear and front
of the Top Shield.
Then, slide the Top
Shield upward.
Locate the Reed Switch (21). Turn the Pulley (13) until
a Pulley Magnet (16) is aligned with the Reed Switch.
Loosen, but do not remove, the indicated M4 x 16mm
Screw (64).
Slide the Reed Switch (21) slightly closer to or away
from the Pulley Magnet (16), and then retighten the
M4 x 16mm Screw (64). Turn the Pulley (13) for a
moment. Repeat these actions until the console dis-
plays correct feedback.
When the reed switch is correctly adjusted, reattach
the top shield.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted. To adjust
the drive belt, you must remove the top shield, the
right pedal, and the right shield (see the instructions
below).
See the drawing at the left. Using a flat screwdriver,
release the tabs near the rear and front of the Top
Shield (9). Then, slide the Top Shield upward.
Next, using an adjustable wrench, turn the right pedal
counterclockwise and remove it. Then, remove the
screws from the right and left shields, and gently
remove the right shield.
Loosen the M6 x 20mm Hex Screw (60). Then, tighten
the M10 x 50mm Hex Screw (33) until the Drive Belt
(23) is tight.
When the Drive Belt (23) is tight, tighten the M6 x
20mm Hex Screw (60).
Then, reattach the right shield, the right pedal, and the
top shield.
MAINTENANCE AND TROUBLESHOOTING
64
21
9
13
16
23
33
60
Loading ...
Loading ...
Loading ...