Loading ...
Loading ...
Loading ...
If convertedto
NaturalGas
NaturalGasUse
This installation must conform with local
codes and ordinances**. In the absence of
local codes, installations must conform with
either the National Fuel Gas Code ANSI
Z223.1, or CANtCGA-B149.1 * Natural Gas
and Propane installation code.
• Open shutoff valve in the gas
supply line. The valve is open when the
handle is parallel to the gas pipe.
Test all connections by brushing on an
approved non-corrosive leak-detection
solution. Bubbles will show a leak. Correct
any leak found.
valve_ee
Explosion Hazard
Use a new AGA or CSA approved
"outdoor" gas supply line.
Securely tighten all gas connections.
Failure to do so can result in death,
explosion, or fire.
• Make gas connections.
A combination of pipe fittings must be
used to connect the grill to the existing
gas line.
• If local codes permit, use an outdoor
flexible stainless steel tubing gas
connector, design-certified by AGA or
CSA International, to connect the grill to
the rigid gas supply line. 5/8" diameter
line is recommended. Using a wrench to
tighten, connect the gas supply to the
grill. Use pipe joint compound on all non-
flared male threads. Do not kink or
damage the flexible connector when
moving the grill.
• Pipe-joint compounds suitable for use
with L.R gas must be used. Do not use
Teflon_'tape.
/
rear of 1/2" g.rill
grill
flexiblegas
connector
Copies of the standards iisted may
be obtained from:
*CSA International
8501 East Pleasant Valley Rd.
Cleveland, Ohio 44131-5575
** for local codes, contact your local
building inspector
@Teflon is a registered trademark of E.I. Du Pont
8 de Nemours and Company.
Loading ...
Loading ...
Loading ...