Loading ...
Loading ...
Loading ...
ASSEM LY
INSTALL MOWER AND DRIVE BELT • Connect anti-sway bar to chassis bracket under left
(See Figs. 4 and 7) footrest and retain with double {oop retainer spring.
Be sure tractor is on level surface and mower suspension • Turn height adjustment knob clockwise to remove
arms are raised with attachment lift control_ Engage park- slack from mower suspension,
ing brake., ° Raise deck to highest position.
. Cut and remove tie down securing anti-sway barn o Assemble gauge wheel bars to brackets using clevis
Swing anti-sway bar to left side of mower deck. pins and double loop retainer springs,
o Slide mower under tractorwith discharge guard to right o Assemble gauge wheels as shown using long shoulder
side of tractor., bolts, 3/8 washers, and 3/8-16 center iocknuts., Tighten
securely,,
. Adjust gauge wheels before operating mower as shown
in the Operation section of this manual,,
IMPORTANT: CHECK BELT FOR PROPER ROUTING IN
ALL MOWER PULLEY GROOVES, INSTALL BELT INTO
ELECTRIC CLUTCH PULLEY GROOVE_
° Install one front link in top hole of the L.H. front mower
bracket and L.,Hofront suspension bracket.. Retain with
two single loop retainer springs as shown.,
° Install second front linkin R,,H,front suspension bracket
only and retain with single Ioop retainer spring as
shown.
o Slide right side of mower deck back and install link in
top hole of R,H.,front mower bracket Retain with single
loop retainer spring as shown..
• Turn height adjustment knob counterclockwise until it
stops.
. Lower mower linkage with attachment lift control.
• Place the suspension arms on inward pointing deck
pins,, If necessary, rock and raise front of mower to
align deck pins with the holes in suspension arms°
Retain with double loop retainer springs.,
SHOULDER
CHASSIS
BRACl ET ANTI-SWAY
DOUBLE LOOP
RETAINER
SPRING
CHECK DECK LEVELNESS
For best cutting results, mower housing should be properly
leveled_ See 'q'O LEVEL MOWER HOUSING" in the
Service and Adjustments section of this manual,.
CHECK FOR PROPER POSUT!ON OF ALL
BELTS
See the figures that are shown for replacing motion, mower
drive, and mower blade drive belts in the Service and
Adjustments section of this manual, Verify that the belts are
routed correctly,. FRONT
SUSPENSION
BRACKETS
DOUBLE LOOP
RETAINER SPRING
(inward pointing deck
pins)
ARMS
FRONT
LINKS
ELECTRIC
CLUTCH
PULLEY
L,H, GAUGE
WHEEL BAR
GAUGE
WHEEL
3f8
WASHER
318-16
CENTER
LOCKNUT
SINGLE
LOOP RETAINER
SPRINGS
FRONT
MOWER
BRACKET
CLEVIS
PINS
IDLER
PULLEY
DISCHARGE
GUARD
LOOP
RETAINER
SPRINGS
FIG. 4
9
Loading ...
Loading ...
Loading ...