Loading ...
Loading ...
Loading ...
$ERV CE A D ADJUSTMENTS
..... i, / J illl,,
TO REPLACE HEADUGHT BULB
° Raise hood.,
. Pull bulb holder- out of the hole in the backside of the
grill..
° Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill,
o Close hood_
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting..
° Check wiring. See electrical wiring diagram in the
Repair' Parts section of this manual.
ADJUSTMENT
SPRING BUSHING
o ATTACHMENT
JAM NUT LIFT SPRING
FIG. 32
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash°
TO ADJUST ATTACHMENT LIFT SPRING
(See Fig. 32)
o While holding spring bushing with wrench, loosen jam
nut..
Turn adjustment bolt clockwise to extend spring and
reduce lift effort for heavier' attachments°
Turn adjustment bolt counterclockwise for' lighter at-
tachments_
- Retighten jam nut against spring bushing,
IMPORTANT: DO NOT ADJUST FOR MAXIMUM SPRING
TENSION WHEN USING LIGHT ATTACHMENTS SUCH
AS A MOWER,, ADJUST LIFT LEVER SPRING TO AID IN
LIFTING ATTACHMENT_ DO NOT OVERPOWER SPRING.
WHEN REMOVING ATTACHMENT, ALWAYS ADJUST
SPRING TENSION TO ITS LOWEST POSITION,•
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 33)
o Raise hood,
. Unsnap headlight wire connector.
= Stand in front of tractoL Grasp hood at sides, tilttoward
engine and lift off of tractor°
° To replace, reverse above procedures°
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 33
26
Loading ...
Loading ...
Loading ...