Loading ...
Loading ...
Loading ...
OOTJNG POaNT$
PROBLEM
Engine continues to run
when operator leaves seat
with attachment clutch
engaged
Poorcut-uneven
Mower blades will not
rotate
Poor grass discharge
Headlight(s) not working
(if so equipped)
Battery wilt not charge
Loss of drive
Engine "backfires"
when turning engine
"OFF"
CAUSE
1 Faulty operator-safety presence control system
1 Worn, bent or loose blade
2 Mower deck not level.
3, Buildup of grass, leaves, and trash under mower
4 Bent blade mandrel
5 Clogged mower deck vent holes from buildup of
grass, leaves, and trash around mandrels
2
Obstruction in clutch mechanism
Worn/damaged mower drive belt.
3 Frozen idler puliey.
4 Frozen blade mandret
t Engine speed too slow
2 Travel speed too fast.
3 Wet grass..
4 Mower deck not level
5 Low/uneven tire air pressure
6. Worn, bent or loose btade
7. Buildup of grass, _eaves and trash under mower
8. Mower drive belt worn
9. Blades improperly installed
10. Improper blades used.
11 Clogged mower deck vent ho_es from buildup of
grass, leaves, and trash around mandrels.
1 Switch is "OFF
2 Bulb(s) burnedout
3. Faufty light switch.
4.. Loose or damaged wiring.
5, Blown fuse..
1 Bad battery cell(s)..
2 Poor cable connections..
3 Faulty regulator (if so equipped)
4 Faulty alternator.
1, Freewheel control in "disengaged" position
2. Motion drive belt worn, damaged or broken.
3, Air trapped in transmission during shpment
or servicing,
t, Engine throttle control not set at "SLOW"
position for 30 seconds before stopping engine
CORRECTION
,, ,=,=l,i=,=lll=,lllL =
Check wiring, switches and connections If not
corrected, contact an authorized service center/
department
,/,J,,, ,, ,ll i ill ,
1. Replace blade.. Tighten blade bolt,.
2. Level mower deck
3, Clean underside of mower housing
4. Replace bfade mandrel
5.. Clean around mandrels to open vent ho_es.
1 Remove obstruction
2 Replace mower dr_ve belt.
3 Replace idler pulley,.
4 Replace blade mandrel.
t Place throttle control in "FAST" position.,
2 Shift to slower speed,
3 Allow grass to dry before mowing.,
4 Levet mower deck
5 Check tires for proper air pressure,
6 Replace/sharpen blade Tighten blade bolt..
7 Clean underside of mower housing
8 Replace mower drive belt
9 Reinstall blades sharp edge down.
10 Replace with blades listed in this manuaE
tl Clean around mandrels to open vent holes.
1., Turn switch "ON",.
2. Replace bulb(s)
3., Check/replace tight switch
4,. Check wiring and connections,.
5 Replace fuse..
1 Replace battery.
2. Check/clean alFconnections.
3 Replace regulator.
4. Replace alternator
t Ptace freewheel control in "engaged" position.
2 Replace motion drive belt..
3. Purge transmission
1,_ Move throttle control to "SLOW" position and atlow
to idle for 30 seconds before stopping engine
3O
Loading ...
Loading ...
Loading ...