Loading ...
Loading ...
Loading ...
16
X E19 5 STEP FOUR
HARDWARE FOR STEP 4
PART TYPE DESCRIPTION QTY
115 PHILLIPS HEAD SCREW
M5 X12MM
8
119 SHEET METAL SCREW
3.5 X 12MM
6
1. Gather HARDWARE FOR STEP 4.
2. Fasten the two WHEEL COVERS (79) to the
rollers with 4 PHILLIPS HEAD SCREWS (115).
Tighten with the PHILLIPS HEAD SCREW
DRIVER (157).
3. Attach the LEFT AND RIGHT SIDE COVER
(80) to the mid-stabilizer tube with 2 PHILLIPS
HEAD SCREWS (115). Attach the RIGHT
SIDE COVER (85) and LEFT SIDE COVER
(86) to the rear stabilizer tube with 2 PHILLIPS
HEAD SCREWS (115). Tighten all 4 screws with
the PHILLIPS HEAD SCREW DRIVER (177).
4. Install the LEFT HANDLE BAR COVERS (81
& 82) and RIGHT HANDLE BAR COVERS
(83 & 84) over the Handle Bar axle connections
with 3 SHEET METAL SCREWS (119) on each
side. Tighten with the PHILLIPS HEAD SCREW
DRIVER (157).
5. Look closely at the four oor levelers underneath
the middle and rear of the elliptical. If any of these
aren’t in contact with the oor, use the WRENCH
(109) to loosen the bottom nut. Once the nut has
been loosened, turn the rubber caster clockwise
until it makes solid contact with the oor. Retighten
the bottom nut to prevent it from moving.
Loading ...
Loading ...
Loading ...