Loading ...
Loading ...
Loading ...
6. Fan Assembly (ushmount).
motor housing
Remove and set aside canopy cover to reveal
6 holes. Notice that 3 of these holes are larger than
the rest of them.
If there are only 3 screws in top of motor housing,
please proceed to next paragraph. If there are
6 screws in top of motor housing, remove every
other screw and lock washer.
Remove set screws from motor housing yoke. Thread
wiring and safety cable through canopy. Place
canopy over yoke, aligning larger holes in canopy
with the 3 existing screws in top of motor housing.
Insert the 3 screws and 3 lock washers that were
removed (if there were only 3 screws located in top
of motor housing, these screws/lock washers will be
located in one of the hardware packs) into the
remaining holes. Securely tighten these screws.
To prepare the fan for wiring, hang fan onto hanging
bracket by sliding the canopy over the hanging
bracket tab. (Use one of the non-slotted holes on the
rim of the canopy to do so.)
canopy
motor housing
(top)
hanging
bracket tab
canopy
yoke
canopy
canopy cover
set screw
page 6
5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box
and able to support the fan you are now ready to
hang your fan. Grab the fan rmly with two hands.
Slide downrod through opening in hanging bracket
and let hanging ball rest on the hanging bracket.
Turn the hanging ball slot until it lines up with the
hanging bracket tab.
WARNING: Failure to align slot in hanging ball with
tab in hanging bracket may result in serious injury or
death.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you once
you are set on the ladder.
hanging ball slot
hanging bracket tab
motor housing
Loading ...
Loading ...
Loading ...