Loading ...
Loading ...
Loading ...
page 5
5. Fan Assembly.
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
downrod
electrical wiring
canopy
motor
housing
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin
and clip. Lower hanging ball and remove stop pin.
Then slide hanging ball o downrod. [Refer to
diagram 1.]
Loosen yoke set screws and nut at top of motor
housing. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the
downrod. [Refer to diagram 2.]
Determine the length of downrod you wish to use.
Thread electrical wires through downrod and pull
extra wire slack from the upper end of the downrod.
[Refer to diagram 2.]
Insert downrod in the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert
pin and clip that were previously removed. Tighten
yoke set screws and nut securely. [Refer to
diagram 2.]
Slide yoke cover over the downrod and lower
completely (until it touches the motor housing).
Then, slide canopy over downrod. [Refer to
diagram 3.]
Thread wires through hanging ball; then, slide
hanging ball over downrod. Insert stop pin into top
of downrod and raise hanging ball. Be sure stop pin
aligns with slots on the inside of the hanging ball.
Tighten set screw securely. [Refer to diagram 4.]
WARNING: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming
loose and possibly falling.
["Fan Assembly" continued on next page.]
diagram 1
downrod
electrical wiring
yoke set screw
and nut
pin
clip
motor
housing
diagram 2
diagram 3
set screw
hanging ball
canopy
stop pin
electrical wiring
diagram 4
set screw
hanging ball
stop pin
pin clip
yoke cover
Loading ...
Loading ...
Loading ...