Loading ...
Loading ...
Loading ...
page 4
ON
OFF
ON
OFF
4. Hanging Bracket Installation.
3. Installation Preparation.
Turn o circuit breakers to current xture from breaker
panel and be sure operating light switch is turned to the
OFF position.
WARNING: Failure to disconnect power supply prior to
installation may result in serious injury.
Remove existing xture.
WARNING: When using an existing outlet box, be sure the
outlet box is securely attached to the building structure and
can support the full weight of the fan. Ensure the outlet box is
clearly marked "Suitable for Fan Support." If not, it must be
replaced with an approved outlet box. Failure to do so can
result in serious injury.
CAUTION: Be sure outlet box is grounded properly and that a
ground wire (GREEN or bare) is present.
Partially loosen screws in slotted holes of canopy. Remove
the other 2 screws and star washers--save for later use.
Twist canopy to remove hanging bracket.
Install hanging bracket to outlet box using original screws,
spring washers and at washers provided with new or
original outlet box.* If installing on a vaulted ceiling, face
opening of hanging bracket towards high point of ceiling.
Arrange electrical wiring around the back of the hanging
bracket and away from the hanging bracket opening.
*Note: It is very important that you use the proper hardware
when installing the hanging bracket as this will support the
fan.
hanging bracket
spring washers
outlet box screws
at washers
7 feet
(2.13 m) (76 cm)
30
inches
blade edge
12ft. - 20ft.
12ft. - 20ft.
(3.66m - 6.1m)
(3.66m - 6.1m)
To prevent personal injury and damage, ensure that
the hanging location allows the blades a clearance of
7 ft. (2.13m) from the oor and 30in. (76cm) from any
wall or obstruction.
This fan is suitable for room sizes up to 400 square
feet (37.2 square meters).
This fan can be mounted with a downrod on a regular
(no-slope) or vaulted ceiling. The hanging length can
be extended by purchasing a longer downrod
(0.5in./1.27cm diameter). After installing hanging
bracket, continue to Section 5 on page 5 for those
instructions. Fan can also be mounted using
ushmount installation only on a regular (no-slope)
ceiling. After installing hanging bracket, continue to
Section 6 on page 6 for those instructions..
Installation requires these tools:
Phillips screwdriver, at-head screwdriver, adjustable
pliers or wrench, stepladder, wire cutters, and rated
electrical tape.
Vaulted ceiling
angle is not to
exceed 25 degrees.
ushmount
installation
Loading ...
Loading ...
Loading ...