Loading ...
Loading ...
Loading ...
Page 14 of 33
Liquid Propane Gas Requirements (Cont’d)
The regulator probe also contains a flow-sensing element, which will limit the flow
of gas to the regulator to a manageable amount (10 cubic feet per hour) in the event
of a hose or regulator failure, or a leak. If it is evident that the flow-limiting device
has activated, the cause of the excessive flow should be determined and corrected
before using your grill again.
Improper lighting procedures can also cause the flow-limiting device to
activate, resulting in reduced heat output. If this is suspected, shut off all
burner controls and cylinder valve, and carefully repeat lighting instructions
step by step. Do not remove the nut and probe and do not attempt to connect
to anything other than a mating Type I (Q.C.C.1) cylinder valve.
DANGER:
Never connect a propane pizza oven to an unregulated propane gas supply or
other gas type.
Do not attempt to alter the hose or regulator in any way.
Do not allow the hose to come in contact with any hot surfaces of the pizza
oven.
Visually inspect the entire length of the hose assembly before each use for any
evidence of damage (cuts, cracks, burns) or excessive wear. If found, replace
the assembly before using your pizza oven.
The connection fitting must be protected when disconnected from the
LP cylinder. If the fitting is allowed to drag on the ground, damage to
the fitting may occur resulting in leaks or an incomplete connection.
Dirt could also enter the small inlet hole, blocking gas flow
completely.
Loading ...
Loading ...
Loading ...