Loading ...
Loading ...
Loading ...
17
en
Control panel/ Operation
OPERATION
Turning the appliance on
Please note: Before plugging the appliance
check: the caps on the back of the unit are correctly
inserted and screwed on the drainage hose 10.
Plug the appliance into the mains. Press the ON/STAND-BY
button (A) (when turned on, the local air conditioners tarts
operating in the same mode as when it was turned o). The
display shows the room temperature. Press the MODE button
(B) until the indicator light correspondingto the required
mode lights up:
Light (O): air-conditioning mode
Light (N): fan mode
Light (P): dehumidifying mode
Air-conditioning mode
Ideal for hot humid weather when you need to cool and
dehumidify the room. By default, the room temperature is
displayed. Light (S) is on. To set the required temperature,
press the + (E) or - (F) buttons until the required temperature
is displayed (to switch between °Fand °C, press the E and F
buttons together for a few seconds). Light (T) comes on
and light (S) goes o. Fifteen seconds after setting the
temperature, the display swit-ches back to room temperature.
Light (S) comes on again. You can adjust temperature in air
conditioning mode only. Then select the fan speed by pressing
the FAN button (C) untilthe indicator light corresponding to
the required fan speed lightsup:
MAX: the local air conditioner operates at maximum
to reach the required temperature as rapidly as
possible.
MED: reduces noise levels but still maintains a good level
of comfort
Description of the control panel
A ON/STAND-BY button
B MODE selection button
Air conditioning, dehumidifying, fan.
C Fan speed selection button
(MAX/MED/MIN)
D Timer button
E Programmed operation increase temperature/time
button
F Programmed operation decrease temperature/time
button
G Display: Displays the temperature values set, room
temperature and the programmed operating time
H Timer in operation indicator light
I/L/M Fan speed lights
(MAX/MED/MIN on some models)
N Fan mode light
O Air-conditioning mode light
P Dehumidifying mode light
Q Alarm light
R Remote control signal receiver
S Light: displays room temperature
T Light: displays set temperature
Important! Never turn the local air conditioner o by unplugging from the mains. Always press the button, then
wait for a few minutes before unplugging. This allows the appliance to perform a cycle of checks to verify operation.
Loading ...
Loading ...
Loading ...