Loading ...
Loading ...
Loading ...
24.DO NOT OPERATE the tool ifyou are under the
influence of any drugs,alcohol or medication that
could affect your abilityto use the tool propedy.
25.ALWAYS operate the band saw in a well-ventilated
area and provide for proper dust removal. Use dust
collection systems whenever possible. Dust
generated from certain materials can be hazardous to
your health,
SPECIFIC SAFETY INSTRUCTIONS FOR
BAND SAWS
TO AVOID INJURY from unexpected movement,
make sure the saw ison a firm, level surface,
propedy secured to prevent rocking. Make sure there
is adequate space for operating. Boltthe saw to a
supportsurface to prevent slipping,walking, or
slidingduring operation.
2. TURN the saw OFF and unplug the saw before
moving it.
3. USE THE CORRECT size and style of blade.
4. USE blades rated at 2480 FPM or greater.
5. MAKE SURE the blade teeth point down and
towards the table. t?lir=rl_,_=]Ol[_[e
6.
BLADE GUIDES, SUPPORT BEARINGS, AND
BLADE TENSION must be properlyadjusted to
avoid accidental blade contact and to minimize blade
breakage. To maximize blade support,always adjust
the upper blade guide and blade guard so that it is
1/8 inchabove the workpiece.
7. TABLE LOCK HANDLE should be tight.
8. USE EXTRA CAUTION with large, very small or
awkward workpieces.
9. USE EXTRA SUPPORTS to prevent workpieces
from slidingoff the table top. Never use another
person to supportthe workpiece.
10. WORKPIECES must be secured so they don't twist,
rock,or slip while being cut.
11. PLAN intricate and smallwork carefully to avoid
pinching the blade. Avoid awkward operation and
hand positionsto prevent accidental contactwiththe
blade.
12.
13.
14.
15.
16.
17.
SMALL PIECES should be secured withjigs or
fixtures. Do not hand hold pieces that are so small
your fingers are under the blade guard.
SUPPORT roundwork properly (with a V-block or
clamped to the miter gauge) to prevent it from rolling
and the blade from biting.
CUT only one workpiece at a time. Make sure the
table isclear of everything except the workpiece and
itsguides before you turn the saw on.
ALWAYS WATCH the saw run before each use. If
there isexcessive vibrationor unusual noise, stop
immediately.Turnthe saw OFF. Unplug it
immediately.Do not startthe saw again untilthe
problemhas been located and corrected.
TO FREE any jammed material, turn the switchOFF.
Remove the switch key and unplug the saw. Wait for
all moving partsto stop before removingjammed
material.
DON'T LEAVE the work area until all moving parts
are stopped. Tochild-proof the workshop, shut OFF
the power to master switchesand removethe switch
key from the band saw. Storeit in a safe place, away
from children.
For your own safety, read the entire instructionmanual
before operating the band saw.
1. Wear eye protection.
2. Do not wear gloves, necktie, or loose clothing.
3. Make sure the saw is on a firm level surface and
properly secured.
4. USE ONLY THE RECOMMENDED ACCESSORIES.
5. Use extra caution with very large, very small, or
awkward workpieces.
6. Keep hands away from the blade at all times to
prevent accidental injury.
7. Do not remove jammed cutoff pieces until the blade
has stopped.
8. Maintain proper adjustment of blade tension, blade
guides and thrust bearings.
9. Adjust upper guide to just clear the workpiece.
10. Hold the workpiece firmly against the table.
_ 4 _ ql
Loading ...
Loading ...
Loading ...