Loading ...
Loading ...
Loading ...
BLADE TRACKING (FIG. J) UPPER BLADE GUIDE ASSEMBLY (FIG K)
_l___l_ll_[l
To avoid injury turn the switch OFF and disconnect the
saw from the power source before making any
adjustments Never make tracking adjustments with the
machine running
1 The blade (1) must be tensioned properly before
adjusting the tracking (See BLADE TENSION on
page 11)
2 Open the wheel cover
3 Move the blade guides (2) and support bearings (3)
away from the blade if necessary (See page 13)
4 Rotate the wheel (4) slowly forward by hand and
check the position of the blade on the wheel The
blade should remain centered on the wheel as it
turns
5 Ifthe blade moves toward the front of the wheel turn
the tracking knob (5) on the rear of the band saw
clockwise This tilts the top of the wheel and moves
the blade toward the center
6 If the blade moves toward the back edge turn the
tracking knob counterclockwise moving the blade
toward the center
NOTE: Turn the tracking knob SLIGHTLY to make
blade trackingadjustments
Fig. J
3
2
To avoid injury turn the switch OFF and disconnect tile
saw from the power source before making any
adjustment NEVER make adjustments with the machine
running
1 Loosen the lock knob (1) and move the blade guide
assembly (2) to 1/8 above the workpiece
2 Rotate the assembly if necessary until the guide
blocks (2) are flat (parallel) to the blade (4) Tighten
the lock knob
Fig. K
Loading ...
Loading ...
Loading ...