Loading ...
Loading ...
Loading ...
7
US
CA
Installation instructions
Water supply
This washer must be plumbed into both a hot and cold water supply or it will not work correctly.
Please ensure that both hot and cold water are connected to the washer.
If you have an uncontrolled water-heating source (eg a wet back or solar heating) you should
have a tempering device fitted. This will ensure the hot water temperature remains within
safe limits. For the most suitable type of tempering device we recommend you contact a local
plumber or plumbing supply merchant.
Inlet water static pressure: Min. 5psi (34kPa) to Max. 150psi (1MPa) is required.
Minimum flow rate from the faucet supplying the clothes washer should be greater than
1
½ gallons/min (6 liters/min) (assumes ½” (12.7 mm) diameter pipes).
Note: your washer does not have an internal water heater to heat water.
Draining
Regularly check that your standpipe or tub / sink is free from lint or other obstructions, which
may affect how your washer works or may cause flooding.
In multi-storey apartments or any upper floor, the washer should be installed on a floor or a tray
equipped with a drain.
Draining must comply with local by-laws.
Accessories and spare parts
Available from your Fisher & Paykel Dealer, Authorized Service Center or www.fisherpaykel.com
Drain Hose Extension Part No. 425627p
Power Cord If the Power Cord of your clothes washer is damaged it must be
replaced by a Fisher & Paykel Authorized Service Agent, as it is not a
standard power cord.
Loading ...
Loading ...
Loading ...