Loading ...
Loading ...
Loading ...
Installation instructions
12
US
CA
Completing your installation
Turn on the water and check all hose connections for leaks. Make sure there are no kinks in the
hoses. Check the hose connections for leaks again after 24 hours.
Uncoil the power cord, remove and discard the plastic pin cover, and plug into wall socket and
turn the power on.
Installation test cycle
Your washer must be correctly installed before use. Check the machine’s installation and
operation using the following procedure:
1
Touch POWER to activate your washer.
2
Touch both the KEYLOCK and OPTIONS buttons at the same time, and hold for three seconds.
3
Touch START/PAUSE to start the installation test cycle. The display will show and the lid
will lock.
4
The machine will beep to signal the end of the installation test cycle. Any faults will be
displayed on the screen (refer to the back of this User Guide to help identify faults). If you need
further assistance, please contact a Fisher & Paykel Customer Care Representative. Refer to
page 53 for contact details.
Note: if there are no faults found, the washer will automatically turn off at the end of the
installation test cycle.
Clothes washer safety
This clothes washer is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the appliance by a person responsible
for their safety.
The lid will be locked from the start of the cycle until the cycle is complete for safety reasons.
To open the lid during operation, you must touch START/PAUSE.
Supervise children at all times to ensure they do not play with the washer.
The only user-removable parts of the washer are the inlet hoses and dispenser funnels. No
other parts are designed to be removed by anyone other than a Fisher & Paykel Authorized
Service Agent.
Loading ...
Loading ...
Loading ...