Loading ...
Loading ...
Loading ...
Dishwasher Installation
CAUTION
Do not remove wood base until gou are
readg to install the dishwasher. The dishwasher will
tip over when the door is opened if base is removed.
STEP 1:PREPARATION
Locate the items in the installation package and set aside for
use in the listed steps:
, Screw kit - Steps Sor !8 and !S
, Junction box cover- Step S or 18
, Drain hose and clamp- Step 7
, Drain hose hanger- Step 17
, Trim pieces (some models) - Step 11
, Owner's Manual - Steps 19 and 22
, Product Samples and/or coupons - Step 22
STEP 2: CHECK DOOR BALANCE
o With dishwasher on the wood base, check the door balance
bg opening and closing the door.
Door is properlg balanced if it gentlg drops from a 1/2 open
position and does not rise from the full open position.
• If necessarg increase or decrease tension
as shown. Latch door and adjust both springs
to the same tension setting to correct balance.
Increase
Spring
Tensior
Insert Hook
Over Bracket
/
/
Decreas,
Spring
Tension
Correct
Jncorrect
Figure G
Tip: Make sure door opens and closes smoothlg
Check door opening and closing. If door does not open easilg
or falls too quicklg, check spring cable routing. The cable is held
in place bg "shoulders" on the pulleg. Check to be sure cable
has not slipped over the pulleg shoulders.
STEP 3: REMOVE WOOD BASE,
INSTALL LEVELING LEGS
IMPORTANT - Donotkickoffwoodbase!
Damage willoccur.
, Move the dishwasher close to the installation location and lag
it on its back.
, Remove the four leveling legs on the underside of the wood
base with a 15/16" socket wrench.
Discard base.
Figure H
, Screw leveling legs back into the dishwasher frame,
approximatelg 1/8" from frame as shown.
STEP 4: REMOVE TOEKICK
, Removethe 2 toekick screws and toekick. Set aside for use in
Step 21.
Figure I
Loading ...
Loading ...
Loading ...