Loading ...
Loading ...
Loading ...
InstallationPreparation
PREPARE HOT WATER LINE
, The line may enter from either side, rear or floor within the
shaded area shown in Figure R
o The line maUpass through the same hole as the electrical
cable and drain hose. Or,cut an additional 1-!/2" diameter
hole to accommodate the water line. If power cord with plug
is used, water line must not pass through power cord hole.
I
I
I
Va ve
Hoti_::::::::::
From
Cabinet
Cabinet Face_,-
Figure F
Water Line Connection
Turn offthe water supply.
Install a hand shut-off valve in an accessible location, such
as under the sink. (Optional, but strongly recommended and
may be required by local codes.)
Water connection is on the left side of the dishwasher. Install
the hot water inlet line, using no less than 3/8" copper tubing.
Route the line as shown in Figure Fand extend forward at
least !9" from rear wall.
AdJustwater heater for !20°F to !50°F temperature.
Flush water line to clean out debris.
The hot water supply line pressure must be 20-120 PSI.
Turn page to begin dishwasher installation.
Loading ...
Loading ...
Loading ...