Loading ...
Loading ...
Loading ...
Dishwasher Installation
STEP 16: CONNECT WATER SUPPLY
Connect water supply line to 90° elbow.
o Slide compression nut, then ferrule over end of water line.
Insert water line into 90° elbow.
Slide ferrule against elbow and secure with compression nut.
IMPORTANT - Check to be sure that door spring
and/or door spring cable do not rub or contact the fill hose or
water supply line.
Test by opening and
closing the door.
Re-route the water
supply lines if a
rubbing noise or
interference
occurs.
Figure V
Hot Water
- 90 ° Elbow Su_' Lne
.... _.............. IJHy
Door Spring
STEP 17: CONNECT DRAIN LINE
The molded end of the drain hose will fit 5/8" through !"
diameter inlet ports on the air gap, waste tee or disposeE
Determine size of inlet port
Cut drain hose connector on the marked line,if required, to fit
the inlet port.
Figure W
Cutting Line
IMPORTANT: Do not cut corrugated
portion of hose
If a longer drain hose is required and you did not purchase
drain hose GPF!OL, add up to 42" length for a total of 120"
(!0 feet) to the factory installed hose. Use 5/8" or 7/8" inside
diameter hose and a coupler to connect
the two hose ends.
Secure the
connection
with hose
clamps.
Figure× Hose Clamp
Coupler
Hose Clamp
Note: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED !0 FEET
FOR PROPER DRAIN OPERATION.
o Connect drain line to air gap, waste tee or disposer
using the previously determined method. Secure hose
with a screw type clamp.
Method I - Air gap with waste tee or disposer
Waste Tee Installation Disposer Installation
FigureY
Method 2 - "High drain loop" with waste tee or disposer
With this method gou will need the drain hose hanger set aside
in Step 1.
Fasten drain hose to underside of countertop with the provided
hanger.
_ _ Drain Hose Hanger
32"
Waste Tee Installation
Figure Z
Disposer Installation
IMPORTANT - When connecting drain line to
disposer, check to be sure that drain plug has been removed.
DISHWASHER WILL NOT DRAIN IF PLUG ISLEFT IN PLACE.
Remove
Drain
Plug
Tip: Avoid unnecessarg service cull charges for a no drain
complaint
Make sure excess drain hose has been pulled through
the cabinet opening. This will prevent excess hose in the
dishwasher cavity from becoming kinked or crushed by the
dishwasher.
Loading ...
Loading ...
Loading ...