GE - General Electric GLD5611N10CS GE dishwasher

User Manual - Page 3

For GLD5611N10CS.

PDF File Manual, 16 pages, Download pdf file

Loading ...
Loading ...
InstallationPreparation
PREPARE DISHWASHER ENCLOSURE
34-1/2"1/4"
Underside of
Countertop
to Floor
ThisWallArea
must beFree
of Pipesor
wires
--5"_ t-
Figure A
_'_ 24"
/
Min.
_FloorMUST be Even
With Room Floor
Cabinets
-Square
and
Plumb
, The rough cabinet opening must be at least 24" deep, 24"
wide and approximatelg 34-1/2" high from floor to underside
of the countertop.
To reduce the risk of electric shock,
fire, or injurg to persons, the installer
must ensure that the dishwasher is
completelg enclosed at the time of
installation.
, The dishwasher must be installed so that drain hose is no
more than 10' in length for proper drainage.
, The dishwasher must be fullg enclosed on the top, sides and
back, and must not support ang part of the enclosure.
CLEARANCES: When
installed into a corner,
allow 2" rain. clearance
between dishwasher
and adjacent cabinet,
wall or other appliances.
Allow 28-3/8" rain. clear-
ance from the front of
the dishwasher for door
opening. Figure B
Figure B
Countertop
Clearance for Door
Opening 2" Minimum
DRAIN REQUIREMENTS
, Follow local codes and ordinances.
, Do not exceed 10' distance to drain.
NOTE:Air gap must be used, if waste tee or disposer
connection is less than 18" above floor to prevent siphoning.
DETERMINE DRAIN METHOD
The tgpe of drain installation depends on the following
questions.
[] Do local codes or ordinances require an air gap?
[] Is waste tee less than 18"above floor?
If the answer to either question is YES,Method 1 MUST
be used.
, If the answers are NO,either method mag be used.
CABINET PREPARATION
, Drill a 1-1/2" diameter hole in the cabinet wall within
the shaded areas shown in Figure A for the drain hose
connection. The hole should be smooth with no sharp edges.
IMPORTANT-when
connecting drain line to disposer, Remove
check to be sure that drain plug has Drain
been removed. DISHWASHERWILL plug
NOTDRAINIF PLUGISLEFTIN PLACE.
Figure C
Method 1 - Air Gap with Waste Tee or Disposer
An air gap must be used when required bU local codes and ordi-
nances. The air gap must be installed according to manufacturer's
instructions.
__ DrainHose,Hanger _ _ DrainHoseHanger
Figure O
Method 2 - "High Drain Loop" with Waste Tee or Disposer
Tip: Avoid unnecessarg service call charges
Always be sure disposer drain plug has been removed before
attaching dishwasher drain hose to the disposer
Loading ...
Loading ...
Loading ...