Loading ...
Loading ...
Loading ...
Dishwasher Installation
STEP 20: DISHWASHER WET TEST
[] Turn on power supplUor plug power cord into outlet,
if equipped.
[] Latch door
[] Push"RinseOnlu" pad.
[] PushStart/Reset pad one time. Dishwasher should start.
[] Check to be sure that water enters the dishwasher If water
does not enter the dishwasher, check to be sure that water
and power are turned on.
[] Check for leaks under the dishwasher. Ifa leak is found,
turn off power at the breaker, and then tighten water
connections. Restore power after leak is corrected.
[] Check for leaks around the door. A leak around the door
could be caused bu door rubbing or hitting against
adjacent cabinets. Reposition the dishwasher if necessaru.
SeeStep !5.
[] The dishwasher will drain and turn off about 5 minutes after
it was started. Check drain lines. If leaks are found, turn off
power at the breaker and correct plumbing as necessaru.
Restore power after corrections are made. See Steps 7
and :!_7.
[] Open dishwasher door and make sure most of the water
has drained. If not, check that disposer plug has been
removed and/or air gap is not plugged. Also check drain
hose to be sure it is not kinked underneath or behind
dishwasher See Step !7.
[] PressStart/Reset pad once again and run dishwasher
through another "RinseOnly" cucle. Check for leaks and
correct if required.
STEP 21: REPLACE TOEKICK
, Placetoekick against the legs of the dishwasher.
Figure CC
Attachment
Screws
, Align the toekick with the bottom edge and make sure it is
against the floor.
Insert and tighten the two toekick attachment screws. The
toekick should stag in contact with the floor
Tip: Reduce sound from under the dishwasher
Hake sure toekick is against floor
STEP 22: LITERATURE
, Be sure to leave complete literature package, these
Installation Instructions and product samples and/or coupons
with the consumer.
Loading ...
Loading ...
Loading ...