GE - General Electric GLD5611N10CS GE dishwasher

User Manual - Page 12

For GLD5611N10CS.

PDF File Manual, 16 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Dishwasher Installation
STEP 18: CONNECT POWER SUPPLY
If a power cord with plug is alreodg installed proceed to
Step 19.
If house wiring is not 2-wire with ground, a
ground must be provided bg the installer.
When house wiring isaluminum, be sure to
use ULListed anti-oxidant compound and
aluminum- to-copper connectors
Inthis step gou will need the junction box cover and the
#!0 Hex head screw from the screw kit set aside in Step !.
. Secure house wiring to the back of the junction box with a
strain relief.
. Locate the three dishwasher wires, (white, black and green)
with stripped ends. Insert dishwasher wires through the small
hole in the junction box bracket. Use UL listed wire nuts of
appropriate size to connect incoming ground to green, white
to white and black to black.
Install the junction box cover using #!0 hex head screw.
Checkto be sure that wires are not pinched under the coveE
Figure AA
Note: Check That Harness
Leads Are Threaded Thru Ground_
Small Hole in Bracket /
White
Do Not
Use
STEP 19: PRETEST CHECK LIST
Review this list after installing your dishwasher to avoid
charges for a service call that is not covered by your
warranty.
[] Checkto be sure power is OFF.
[] Open door and remove all foam and paper packaging.
[] Locate the Owner's Manual set aside in Step !.
[] Readthe Owner's Manual for operating instructions.
[] Check door opening and closing. If door does not open and
close freelg, check for proper routing of spring cable over
pulleg. If door drops or closes when released, adjust spring
tension. See Step 2,
[] Checkto be sure that wiring is secure under the dishwasher,
not pinched or in contact with door springs or other
components. See Step !0.
[] Check door alignment with tub. If door hits tub, level
dishwasher. SeeSteps 14 and !5.
[] Pull lower rack out, about halfway. Check to be sure it does
not roll back or forward on the doon If the rack moves,
adjust leveling legs. See Step !4.
[] Check door alignment with cabinet. If door hits cabinet,
reposition dishwasher. SeeStep !5.
[] Checkthat door spring does not contact water line, fill hose,
wiring or other components. See Step !6.
[] Verify water supply and drain lines are not kinked or in
contact with other components. Contact with motor or
dishwasher frame could cause noise.
[] Turn on the sink hot water faucet and verify water
temperature. Incoming water temperature must
be between !20°F and !50°R A minimum of !20°F
temperature isrequired for best wash performance. See
"Prepare Hot Water Line,"page 5.
[] Add 2 quarts of water to the bottom of the dishwasher to
lubricate the pump seal.
[] Turn on water supply. Check for leaks.Tighten connections
if needed.
[] Remove protective film if present from the control panel
and door.
Loading ...
Loading ...
Loading ...