Loading ...
Loading ...
Loading ...
Transport
8 Transport
46
DANGER!
If the machine is to be transported on a lorry or trailer, loading ramps with a suitable load-bearing ca-
pacity, width and length must be used. The machine must only be loaded with the engine switched off,
without a driver, by being pushed on to the means of transport by an appropriate number of people.
During transport, close the petrol cock (if present), lower the cutting disc, apply the parking brake and
appropriately secure the machine on the means of transport with ropes or chains.
9 Potential faults and how to rectify them
Fault Corrective measureCause
V-belt running not OK
Grinding sounds
Premature V-belt wear
&KHFNWKHFHQWULQJRIWKH9EHOWSXOOH\
the contact surfaces must be clean and
free of burr
Position the V-belt and V-belt tensioner
according to the installation instructions
Reposition the V-belt tensioner according
to the instructions
V-belt pulley installed incorrectly
V-belt does not run over the V-belt
tensioner
The edges of the V-belt and V-belt
idler pulley are in contact
IMPORTANT:
If a fault which is not listed in this table occurs, contact the specialist dealer. Once you have tried all of
the corrective measures described here with no success, contact the specialist dealer.
IMPORTANT:
Only use genuine spare parts from the manufacturer, which you can obtain from your specialist dealer.
This ensures that the implement will work reliably.
Loading ...
Loading ...
Loading ...