Loading ...
Loading ...
Loading ...
Page 17
ENGLISH
SET UP & USE
Step 2: Install the Bottom Cover
Slide the bottom cover into the slots
on bottom surface of the unit as in the
following gure, and x it with the one
screw attached with the unit.
Step 3: Connect the water hose
TEMPORARY CONNECTION
The Quick Connection Adaptor is primarily for quick connection to a single faucet,
such as a typical kitchen sink, in cases where the washer is stored in a different
place than where it is used. (Skip this step if you are connecting the washer to a
sink with separate hot and cold faucets. See PERMANENT INSTALLATION section
below.) The adaptor consists of two parts that quickly connect or disconnect. One
part, the faucet tting, is for connection to the faucet and the other part, the hose
tting, connects to the COLD water hose of the washer.
- Pull back on the white ring to free the faucet tting from the adaptor for
installation into the faucet.
- Screw the end of the COLD water hose onto the base of the hose tting.
- If the faucet has internal screw threads, unscrew the aerator if present from the tip
of the faucet. Then screw the faucet tting into the faucet. Make sure that the black
rubber gasket is on the top of the adaptor before screwing it in.
- If the faucet has external screw threads, remove the gasket from the top of the
faucet tting, and screw the tting over the external threads.
- Pull back on the white ring to connect the two parts of the adaptor back together.
NOTE: When connected to a single faucet that can dispense either hot or cold
water, both hot and cold water can be run through the cold water line.
It is recommended to ONLY run COLD water washes when the adapter is
connected to such a faucet.
Bottom Cover
Cold
Pull down on the white ring
to divide the adaptor into
two parts.
Rubber Gasket
Inner Threads for outer threaded faucet
Outer threads for inner threaded faucet
Top Part: Faucet fitting
Bottom Part: Hose Fitting
Internal Threads External Threads
Rubber Washer
Faucet Connector
Quick Connection Adaptor
Water Inlet Hose
Loading ...
Loading ...
Loading ...