Loading ...
Loading ...
Loading ...
Oven Door
LevemingLegs
- Do not piace excessweweight on or stand on an open oven
door. This couM cause the range to tip over. break the door.
or injure the user.
- Do not attempt [o open or ciose door or operate oven until
door is proper y repiaced.
• Never piace fingers between hinge and front oven frame.
Hinge arms are spring mounted, tf accidentaiiy hit.the hinge
wiii siam shut against oven frame and couid injure your
fingers.
Note: The oven door on a new range may feel "spongy"
when it is dosed. This is normal and will decrease with use.
rear bveling !egs to the floor, This bracket pre-
vents the range from accidentally tipping.
The range should be leveled when installed, if
the range is not level, turn the plastic _.,_o
located at each comer of _,,,_
leveling legs,
the range, until range is level _ _ ANTI-TIP
BRACKET
\ LEVELING LEG
Oven Light
To remove:
1. When cool, open tile oven door to tile first stop position
(opened about four inches}.
2. Grasp door at each side. Do not use the
door handle to lift door.
3. Lift up evenly until door clears hinge
arms.
To replace:
1. Grasp door at each side.
2. Align slots in the door with the hinge arms on the range.
3. Slide the door down onto the hinge arms until the door is
completely seated on the hinges. Push down on the top
corners of the door to completely seat door on hinges. Door
should not appear crooked.
Oven Window
To protect the oven door window:
1. Do not use abrasive cleaning agents such as steel wool
scouring pads or powdered cleansers as they may scratch
the glass.
2. Do not hit the glass with pots, pans, furniture, toys, or other
objects.
3. Do not close the oven door until the oven racks are in place.
Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
date.
- Use a dry potholder to prevent pess!b!e harm to hands
. Do nottouch hot bulb with a damp cloth as this may cause
the bulb to break.
To Replace Oven Light Bulb:
1. When oven is cool, hold bulb cover in place, then slide wire
retainer off cover. NOTE:Bulb cover will fall if not held in place
while removing wire retainer. Bu_oow_
2. Remove bulb cover and light
bulb.
3. Replace with a 40-watt ap-
pliance bulb.
4. Replace bulb cover and se-
cure with wire retainer.
RETAINER
5. Reconnect power to range. Reset clock.
19
Loading ...
Loading ...
Loading ...