Loading ...
Loading ...
Loading ...
33
SETTING OVEN CONTROLS
Steam Clean
The Steam Clean feature oers a chemical free and
time saving method to assist in the routine clean-
ing of small and light soils. For heavier baked on
soils use the Self Clean feature.
Figure 24: Clean around the oven door gasket
Figure 25: Add 1 cup of tap water
Be sure the oven is level and cool before starting
Steam Clean. If the oven temperature is above
room temperature a triple beep will be heard and
the function will not start. Steam Clean produces
best results when started with a cool oven.
To set a Steam Clean cycle:
1. Remove all racks and oven accessories.
2. Scrape or wipe loose debris and grease from
the oven bottom.
3. Pour 1 cup of tap water onto the oven bottom.
(Figure 25) Close oven door.
Important: Opening oven door during Steam Clean
cycle prevents the water from reaching the tem-
perature needed to clean. If the door is left open
once Steam Clean starts, an alarm will sound alert-
ing you to close the door.
• For best results, clean oven immediately after
the cycle is complete. Steam clean works best
for soils on the oven bottom.
• Place a paper towel or cloth in front of the
oven to capture any water that may spill while
wiping out.
• A non abrasive scouring pad, stainless steel
sponge, plastic scraper, or eraser style cleaning
pad (without cleaner) can be used for dicult
soils. Moisten pads with water before use.
• Do not leave the residual water in the oven for
any length of time.
• Some condensation or water vapor may appear
close to the oven vent. This is normal. The oven
gasket may become damp; do not wipe dry.
• Local water sources often contain minerals
(hard water). If hard water deposits occur, wipe
cavity with a 50/50 solution of water and vine-
gar or 50/50 solution of lemon juice and water.
• Steam clean cannot be programmed with a
delay start.
• If Steam Clean results are not satisfactory, run a
Self Clean. See “Steam Clean” on page 33.
4. Press Steam Clean.
5. Press OK/START. St C will appear in the dis-
play.
6. To see time remaining in the Steam Clean cycle
press Steam Clean key. The time left will show
in the display for 6 seconds before returning to
the time of day. If door is open during Steam
Clean for more than 4 minutes, d-O will appear
in the display and the display will sound a triple
beep until the door is closed.
7. When the steam clean cycle is complete an
alert will sound and the END message will show
in the display. Press OFF to return to the clock.
8. Take care opening the door when the steam
clean is finished. Stand to the side of the oven
out of the way of escaping vapor.
9. Wipe oven cavity and bottom. Do not clean
oven door gasket (Figure 24). Avoid leaning or
resting on the oven door glass while cleaning
cavity.
10. To cancel Steam Clean at any time press OFF.
CAUTION
Do not add bleach, ammonia, oven cleaner, or
any other abrasive household cleaners to the wa-
ter used for Steam Clean.
Before cleaning any part of the oven, be sure all
controls are turned o and the oven is cool. The
oven may be hot and can cause burns.
Loading ...
Loading ...
Loading ...