Loading ...
Loading ...
Loading ...
10 English
Wall Venting
To make a 3½” x 10½” (8.9 cm x 26.7 cm) rectangle in the wall:
1. Make 2 lines by measuring
4.2
⁄10” (1.1 cm) and 3
.7
⁄10” (9.4 cm) down
from underside of cabinet and mark on the centerline on the back wall.
2. Mark lines 5¼” (13.3 cm) to the right and left of the centerline on the
wall.
3
7
⁄10”
(9.4 cm)
4.2
⁄10”
(1.1 cm)
5
1
/4”
(13.3 cm)
5
1
/4”
(13.3 cm)
Centerline
3. Use saber or keyhole saw to cut a rectangular opening in the wall for
the vent.
For 7" (17.8 cm) Round Vent System (Roof Venting)
To make a circular vent opening on the underside of the cabinet top:
1. Mark a centerline on the underside of the top of cabinet.
2. Mark a line 5” (12.8 cm) from the back wall on the underside of the top
of cabinet.
3. Use a compass or a circle template to draw a circle with a diameter of
7½” (19 cm).
4. Use saber or keyhole saw to cut the circular vent opening. Repeat
steps 1-3 for the underside of the top of the cabinet.
Cabinet cutouts
*From wall, not cabinet frame
*5”
(12.8 cm)
C
enterline
Drill Electrical Opening
1. Using a 1¼" (3 cm) drill bit, drill the hole in the dot marked previously
at the electrical strain relief.
Prepare Range Hood Vents
A
B
C
D
E
Install Strain Relief
1. Install a UL listed/CSA approved ½" (13 mm) strain relief (A).
For non-vented (Recirculating) Installations
• Remove the (2) T10 Torx® screws and remove the top, front
rectangular vent cover (E). Go to "Electrical Connection" step.
For 3¼" x 10" (8.3 x 25.4 cm) Rectangular Vent Installations
• For top vent installations, remove the top rectangular vent knockout
(C).
OR
• For wall vent installations, remove the rear rectangular vent
knockout (B).
For 7" (17.8 cm) Round Vent Installations
• Remove both top knockouts (C and D).
Attach Vent Damper or Transition
3¼" x 10" (8.3 x 25.4 cm) Rectangular Vent Damper
1. Using (2) short Phillips head screws, install the 3¼" x 10" (8.3 x 25.4
cm) rectangular damper over the top or rear vent knockout removed in
previous step.
NOTE
If the wall cap used has a damper and it interferes with the rectangular
damper, remove the rectangular damper ap.
Installation Instructions
Installation Instructions
Loading ...
Loading ...
Loading ...