Loading ...
Loading ...
Loading ...
If Connecting Dishwasher with Direct Wiring:
� Use flexible, armored, or nonmetallic
sheathed copper wire with grounding
wire that meets the wiring
requirements for your home and
local codes and ordinances.
� Use a UL-listed/CSA-approved metallic strain relief.
INSTALLATION INSTRUCTIONS
WARNING
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
You Need To:
� Slowly open dishwasher door while someone grasps the rear
of the dishwasher. Remove shipping materials and drain hose.
Close dishwasher door until latched.
NOTE: Each dishwasher is tested at the factory and may
contain some residual water in the tub as a result of the test.
� Observe all governing codes and ordinances.
� Install this dishwasher as specified in these instructions.
� Installation should be performed by a qualified
service technician.
� The dishwasher must be installed to meet all electrical
and plumbing national and local codes and ordinances.
� Care shall be exercised when the appliance is installed
or removed to reduce the likelihood of damage to the
power cord.
WARNING: To reduce the risk of electric shock, fire, or injury to
persons, the installer must ensure that the dishwasher is
completely enclosed at the time of installation.
Before You Begin
WARNING
Electrical Shock Hazard
Disconnect electrical power at the fuse box or circuit
breaker box before installing appliance.
Failure to do so can result in death or electrical shock.
1. Disconnect power
Disconnect electrical power at the fuse box or circuit breaker
box before installing dishwasher.
2. Shut off water supply
Shut off water supply to the dishwasher.
Prepare Cabinet Opening – New
Utilities
3. Drill hole locations – new construction
A
B
A. Optional location
B. Preferred location
The power-supply receptacle for the appliance shall be
installed in a cabinet or on a wall adjacent to the
undercounter space in which the appliance is to be installed.
NOTE: Refer to the “Cabinet Opening Dimensions” section
for the correct hole placement and dimensions of the shaded
area.
Drill a 1
1
/
2
" (38 mm) drain hole in the side or rear of cabinet,
depending on the location of the drain hose routing and drain
hose connection location.
Drill a 1/2" (12.7 mm) water supply hose hole in the side or
rear of cabinet, depending on location of water supply routing
and connection location.
Drill a 1
1
/
2
" (38 mm) electrical conduit hole in the right-hand
side or rear of the cabinet.
1
/
1/2"
9
Loading ...
Loading ...
Loading ...