Loading ...
Loading ...
Loading ...
16
Install Door Handle (on some
models)
29. Install door handle
A
D
B
C
A. Setscrew (in
bottom of handle)
B. Hex key
C. Handle
D. Mounting stud
IMPORTANT: Do not scratch the front panel during this
procedure. If door panel has a protective film, peel film back
past the point of the handle studs before installing handle.
Handle is easiest to install while unit is on its back.
Remove the door handle and hex key from the packaging.
Setscrews are already installed in the handle. Place handle
on mounting studs with the setscrews facing down. Push the
door handle tightly against the door. Insert the short end of
the hex key into the setscrews. Tighten the setscrews 1/4
turn past snug.
Retain hex key with Owner’s Manual.
Place Dishwasher in Cabinet
WARNING
Excessive Weight Hazard
Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
30. Stand dishwasher upright
Using 2 or more people, stand the dishwasher up.
NOTE: Do not install kick plate until instructed to do so.
IMPORTANT: If wheels were removed, cover the floor when
moving the dishwasher. Slowly move dishwasher completely
into cabinet opening. Do not kink or pinch water line, drain
hose, power cord, or direct wire between dishwasher and
cabinet. Remove cardboard from under dishwasher.
It is all right if dishwasher fits tightly into cabinet opening. Do
not remove insulation blanket—the blanket reduces the
sound level.
NOTE: Route water supply, drain hose, and power cord out
the rear of the dishwasher.
31. Move dishwasher close to cabinet opening
A
B C
A. Water line
B. Cable
C. Drain hose
Route the utilities through the holes in the cabinet and pull
the slack out at the same time as the dishwasher is pushed
into the cabinet.
Loading ...
Loading ...
Loading ...