Loading ...
Loading ...
Loading ...
4. Sand holes smooth
A
B
A. Wood cabinet
B. Metal cabinet
Wood cabinet: Sand the hole until smooth.
Metal cabinet: Cover edges of hole with grommet included
with power cord kit. See the “Tools and Parts” section for part
details.
Helpful Tip: Wiring the dishwasher will be easier if you route
the cable into the cabinet opening from the right-hand side.
Install Optional Moisture Barrier
(Recommended for Wood
Countertops)
Moisture barrier/Wood shims
A
B
A. Install wood shims
B. Moisture barrier
Make sure the area under the cabinet is clean and dry for
installation of the moisture barrier. Remove the backing of the
moisture barrier and apply to underside of the countertop along
the front edge of the counter.
NOTE: Install wood shims if side anchoring and the gap between
sides of the dishwasher are greater than 1/2" (12.7 mm) on each
side or are greater than the length of the anchor screws.
5. Built-up floors add shims as needed
101 mm
50 mm
Built-up floors: If the kitchen floor is higher than the cabinet
opening’s floor—for example, the kitchen floor tile does not
extend into the cabinet opening—add shims, as needed, in
the area shown to bring the dishwasher up to 34" (864 mm)
below the countertop.
NOTE: Shims must be securely attached to floor to avoid
movement when the dishwasher is in use.
6. If installing into a 33
1
/
2
" (851 mm) opening
Cut insulation blanket along perforation for cabinet opening
height of 33
1
/
2
" (851 mm). For other cabinet opening heights,
do not cut the insulation blanket.
Electrical Connection
For Direct Wire, begin with step 7
For Power Cord, wait until step 22
7. Direct wire route cable
If installing with direct wire, route the cable as shown.
Route cable from power supply through cabinet hole. (Cable
must extend to the right-front side of cabinet opening.) Tape
cable to the floor in area shown. This will prohibit cable from
moving when dishwasher is moved into cabinet opening.
NOTE: If removing a previous dishwasher with a power cord,
you will need to transfer the power cord to the new
dishwasher.
2"
4"
"
70 mm
6”
(152 mm)
10
Loading ...
Loading ...
Loading ...