Loading ...
Loading ...
Loading ...
Instructions
Start
If it is the very first initialization for the dishwasher, then the Choose Program screen is shown:“HELLO”
I .Dark after Welcome-letters ,
2 .After Welcome-letters passing: CHOOSE p (Choose Program);
3.Continuous Welcome-letters.
After pushing " "(program) button, program selection is started.
For the next starts, the last program used, should be pre-selected, so that display shows the last run
program and can be started immediately by pushing "Start/Pause".
By Pushing " " (Program button), you can choose the
washing program/ profile. The Washing profile name is shown
in the display and is shown in a short form:
Alternating to the program name (short form) at display the
related program time segments are displayed. This alternating/
switching between program name and related program time (e.g. every
2seconds) ends by pushing "Start/Pause" to start the program. From
there on only the program time is displayed and counted down based on
the profile definition.
Operating Mode
After the program is started, only the program time is displayed and starts to count down as long as the
program is in progress. Time values are display steadily, the dots in between are displayed with flash.
By pushing the Start/Pause button during the program is running, the program is paused.
At display the related program time is displayed flashing. The dots in between are displayed steadily. When the "
"button is pushed again, program continues. Remaining time display continues counting down.
Add the rinse aid
How to add the rinse aid
Note:lf there is no distributor model, cannot add the rinse,
Combination of washing the dishes is recommended to be used.
1. Counterclockwise rotate and remove the plug.
2. 2.Add the rinse aid into the round hole. Notice to prevent the rinse
3. Aid from splashing outward the feeder.
Important note!
The spilled rinse aid, if any, must be wiped off; otherwise,
Much bubbles may be produced, resulting in damage
to dishwasher and loss of warranty.
3.Refit the plug, and then clockwise rotate the plug in place.
Important note!
Ensure that the plug is tightened, and the plug handle is vertical.
The dosage of rinse aid for every washing process shall be
adjusted between "0" (min.) and "5" (max.) according to the
local water hardness. Please refer to the section "Preferred
Options" in "Quick Guidance" for details.
If there are many bubbles after washing, the dosage
Add the rinse aid into the feeder
setting of rinse aid shall be decreased.
If the dish drying effect is not good, the dosage setting
of rinse aid shall be increased.
If you live in the hard-water region where no water softener
is installed in the water supply pipeline, it is suggested to adjust
the dosage setting of rinse aid to "5".
Rotate and tighten the plug
the
plug
16 29
Dosage of rinse aid
Press the start/pause “ ”button for 3-5seconds to cancel the
current program.
Loading ...
Loading ...
Loading ...