Loading ...
Loading ...
Loading ...
29
TROUBLESHOOTING
I
L
G
H
J
K
weber.com
9. Remove the auger/motor assembly by first removing three screws
and washers from the mounting bracket (G). Carefully slide and twist
the auger/motor assembly out and away from the grill (H).
NOTE: Visually note the orientation of the motor when installed on the grill.
10. Clean the auger tube and auger/motor assembly to remove any
pellets and debris that may have been jamming the auger.
11. Before reinstalling the auger/motor assembly back into the auger
tube, verify that the shear pin and hardware are still intact (I). Both
sides of the pin should be fully engaged and visible. The auger
should not pull away from the motor. If the shear pin or hardware are
broken, it should be replaced before reassembling. Contact a WEBER
Customer Service Representative in your area using the contact
information on our website for a replacement.
12. Reinstall the auger/motor assembly by sliding the auger through
the auger tube and fastening the assembly with three screws and
washers (J) (K).
CAUTION: Make sure the auger/motor assembly is in the correct orientation
when reinstalling into the auger tube. See illustration (K).
13. Connect the motor’s electrical connection. Make sure the connector is
securely joined to the motor (L).
Loading ...
Loading ...
Loading ...