Loading ...
Loading ...
Loading ...
25
TROUBLESHOOTING
G
J
H
I
weber.com
7. Clean the auger tube and auger/motor assembly to remove any pellets
and debris that may have been jamming the auger.
8. Before reinstalling the auger/motor assembly back into the auger tube,
verify that the shear pin and hardware are still intact (G). Both sides of
the pin should be fully engaged and visible. The auger should not pull
away from the motor. If the shear pin or hardware are broken, it should
be replaced before reassembling. Contact a WEBER Customer Service
Representative in your area using the contact information on our website
for a replacement.
9. Reinstall the auger/motor assembly by sliding the auger through the
auger tube and fastening the assembly with three screws and washers
(H) (I).
CAUTION: Make sure the auger/motor assembly is in the correct orientation when
reinstalling into the auger tube. See illustration (I).
10. Connect the motor’s electrical connection. Make sure the connector is
securely joined to the motor (J).
Loading ...
Loading ...
Loading ...