Loading ...
Loading ...
Loading ...
www.123filter.com | (678) 261-7611 | [email protected]om
Page 22
Troubleshooting
ISSUE POSSIBLE CAUSE POSSIBLE SOLUTION
Unit fails to initiate a
regeneration cycle
No power supply Check electrical service, fuse,
etc.
Power failure
Reset time.
Low water pressure
Iron or scale builds up in line
feeding unit
Clean pipes.
Iron build up inside
the
valve
or tank
Clean control and add resin
cleaner to clean bed. Increase
regeneration frequency.
Inlet of control plugged due to
foreign material
Remove the piston and clean the
control valve.
Control valve without
display
Power failure, the power adapter is
not plugged in
Check the power supply to
ensure regular or restored
power supply.
Power off while regeneration
Turn the bypass valve to the
bypass position or close the
control valve.
Control valve failure
Contact dealer.
Poor water quality
The
Control valve clock is
inaccurate due to a power failure,
causing the regeneration start time to
be changed
Adjust the control valve’s
current time. For operating
procedures, refer to the current
time in the control valve
manual.
Poor water quality
Add one regeneration process.
Refer to the setting of the
regeneration cycle in the
control valve manual for the
operating procedure.
Filter failure
Change the filter or contact
your dealer
.
Regenerate too often or too little
The regeneration cycle
setting
is not optimal. Adjust the
regeneration cycle of the
control valve and refer to the
setting of the regeneration cycle
in the control valve manual for
the operating procedure.
Incoming water quality does not
meet national municipal tap water
standards
Contact the relevant local water
supply department.
Loading ...
Loading ...
Loading ...