Loading ...
Loading ...
Loading ...
www.123filter.com | (678) 261-7611 | [email protected]om
Page 10
Installation Requirements
(1) Equipment Installation Conditions
The installation location should be well-ventilated and protected against wind and rain. Avoid
direct sunlight and radiation from any heat sources.
The relative humidity of the installation and use environment should not exceed 75% RH.
Equipment and pipes installed outdoors should be insulated and frost-proofed.
The inlet water must meet the water quality standard of municipal tap water. The water pressure is
to be 20 psi - 125 psi.
There should be a floor drain within 500mm of the installation position. Ensure the floor drain
remains unobstructed and is not tightly connected with the equipment’s sewage pipe.
There should be a sewage pipe with an outer diameter of DN50 PVC within 100 mm of the edge of
the material. This sewage pipe should remain open at all times.
If the equipment is installed indoors, the installation equipment must be equipped with water
leakage protection.
A 120V/60Hz five-eye power socket must be used. The product’s power supply and plug must be
installed in a wall position higher than 500 mm above the ground and equipped with proper
grounding, leakage protection, and waterproof devices.
The installation location should be level, and the ground bearing capacity should be greater than
300 kg/m
2
.
(2) Installation Precautions
During transportation, this product is strictly prohibited from being placed horizontally, and it
should not be inclined to less than 45°.
Ensure that there is proper space around the device and do not apply any external force to the
device or its connecting pipes.
Do not install this product near corrosive substances or gases, as this may cause the product to
corrode.
Do not place flammable items on or near the product.
All inlet and outlet pipes are recommended to use water pipes and fittings that meet the appropriate
standards of domestic drinking water. The connection of water pipes and circuits should comply with
national or industry standards, and the pipe connections should comply with relevant federal
installation regulations.
Be sure to pay attention to the height and placement angle of the pipeline when it is connected.
After the pipeline is properly connected, there should be no evidence of stress, so as to avoid damage
to the water pipe or the product due to the pressure of the pipeline after long-term use.
There must be sufficient space (about 10 cm) between the outlet of the sewage pipe and the sewage
to prevent sewage from flowing back to the product; the underground sewage pipe should be 30 cm
higher than the ground, and the sewage pipe should be fixed on the sewage pipe (do not insert the
sewage pipe directly into the sewage.
Loading ...
Loading ...
Loading ...